Examples of Ohm's law in the following topics:
-
- This important relationship is known as Ohm's law.
- This relationship is also called Ohm's law.
- Ohm's law (like Hooke's law) is not universally valid.
- The many substances for which Ohm's law holds are called ohmic.
- The other two devices do not follow Ohm's law.
-
- According to Ohm's law, The electrical current I, or movement of charge, that flows through most substances is directly proportional to the voltage V applied to it.
- Ohm's law can therefore be written as follows:
- More specifically, Ohm's law states that R in this relation is constant, independent of the current.
- To solve this problem, we would just substitute the given values into Ohm's law: I = 1.5V/5Ω; I = 0.3 amperes.
- If we know the current and the resistance, we can rearrange the Ohm's law equation and solve for voltage V:
-
- In a circuit with a resistor and an AC power source, Ohm's law still applies (V = IR).
- Ohm's law applies to AC circuits as well as to DC circuits.
- Apply Ohm's law to determine current and voltage in an AC circuit
-
- There, we used the Ohm's law (V=IR) to derive the relationship between voltage and current in AC circuits.
- In this and following Atoms, we will generalize the Ohm's law so that we can use it even when we have capacitors and inductors in the circuit.
- Because it is still a voltage divided by a current (like resistance), its unit is the ohm.
- This is considered to be an effective resistance of the capacitor to AC, and so the rms current Irms in the circuit containing only a capacitor C is given by another version of Ohm's law to be $I_{rms} = \frac{V_{rms}}{X_C}$, where Vrms is the rms voltage.
- Note that XC replaces R in the DC version of the Ohm's law.
-
- Using Ohm's Law to Calculate Voltage Changes in Resistors in Series
- According to Ohm's law, the voltage drop, V, across a resistor when a current flows through it is calculated by using the equation V=IR, where I is current in amps (A) and R is the resistance in ohms (Ω).
- A brief introduction to series circuit and series circuit analysis, including Kirchhoff's Current Law (KCL) and Kirchhoff's Voltage Law (KVL).
-
- According to Ohm's law, the currents flowing through the individual resistors are $I_1 = \frac{V}{R_1}$, $I_2 = \frac{V}{R_2}$, and $I_3 = \frac{V}{R_3}$.
-
- By combining Ohm's law (Irms=Vrms/Z; Irms and Vrms are rms current and voltage) and the expression for impedance Z, from:
- This response makes sense because, at high frequencies, Lenz's law suggests that the impedance due to the inductor will be large.
-
- A number of electrical laws apply to all electrical networks.
- These include Ohm's law, which has been discussed in the "Resistance and Resistors" module, Kirchhoff's current and voltage laws, which are covered in the "Kirchhoff's Rules" module.
- The two Kirchoff laws along with the current-voltage characteristic (I-V curve) of each electrical element completely describe a circuit.
- The current i flowing through the circuit is given by Ohm's law.
-
- In an AC circuit with an inductor, the voltage across an inductor "leads" the current because of the Lenz' law.
- The rms current Irms through an inductor L is given by a version of Ohm's law: $I_{rms} = \frac{V_{rms}}{X_L}$ where Vrms is the rms voltage across the inductor and $X_L = 2\pi \nu L$ with $\nu$ the frequency of the AC voltage source in hertz.
- Because the inductor reacts to impede the current, XL has units of ohms (1 H=1 Ωs, so that frequency times inductance has units of (cycles/s)(Ωs)=Ω), consistent with its role as an effective resistance.
- The voltage across an inductor "leads" the current because of the Lenz's law.
-
- Kirchhoff's circuit laws are two equations first published by Gustav Kirchhoff in 1845.
- Kirchhoff, rather, used Georg Ohm's work as a foundation for Kirchhoff's current law (KCL) and Kirchhoff's voltage law (KVL).
- Kirchhoff's laws are extremely important to the analysis of closed circuits.
- As a final note, Kirchhoff's laws depend on certain conditions.
- The voltage law is a simplification of Faraday's law of induction, and is based on the assumption that there is no fluctuating magnetic field within the closed loop.